Hexatronic Stingray Air Blown Fiber Installation Tool

The blowing tool consists of a body that guides and feeds the fiber unit into the Microduct. The tool uses both compressed air and an electric motor to feed the fiber. An adjustable magnetic coupling limits feeding force on fiber to avoid damage in case of a sudden stop. A Li-Ion battery pack, fitted in the tool handle, powers the motor. The motor speed and direction is controlled by a trigger switch on the handle. The trigger can temporarily be locked to maintain the speed when blowing.

The blowing tool is designed to be used with Hexatronic Air Blown Fiber only. Fiber units with 1-24 fibers can be installed. Nozzles for 3/2mm, 5/3.5mm and 7/3.5mm Microducts are included.

The blowing tool is normally fed with dry compressed air. The compressed air is connected to the tool with a ¼” standard quick connector. For optimal installation performance, an air flow of 80l/min and a nominal pressure of 8 bar is required. For shorter distances, a smaller compressor or a portable pressure canister with a reduction valve can be used. For very short distances (up to 50 m) such as in small multi dwelling units, the fiber can be fed by the integrated electrical motor only, without using any compressed air supply at all. The integrated display shows information about speed, blown length and battery capacity

• Blowing tool
• Battery charger
• Two Li-Ion batteries
• Set of air filter and valve
• Small toolbox with tools and common replacement parts
• Two fiber guide sets for 2-6 and 8-12 blown fiber units are included
• Nozzles for 3 mm, 5 mm and 7 mm microducts
• Microduct cutter
• User guide
• Carrying case

FIber guide set for 24 fiber blown fibers is available as an optional accessory (not included)

Data Sheet - Hexatronic Air Blown Fiber Installation Tool

Hexatronic Stingray ABT - Replacement Parts Diagram